![]() ![]() one thing I do suggest to anyone who is going to be doing this in the future, when you drill your pilot holes, start with a smaller bit first, move to the size you need, but don't put your bit to far into the chuck of the drill. I found the stud we wanted and was able to get it hung. It seems like a little extra work but it was worth it. Knock your hand along the wall to find out where studs are. Simply move the stud finder along the wall until it indicates the location of a stud. Use a stud finder: A stud finder is a hand-held device that can detect the location of studs behind the wall. If you go through, then there is a stud in that section of the wall finding it will be easy from here on. Here are some steps to help you locate studs in lath and plaster walls. I did this at various heights and would then run a string between the different marks, once I found a line that seemed to be pretty straight I would make one final run with the finder just to make sure my lines were correct. Once you find that, drill a small hole just above it and push a thin nail through to scratch the back of the plaster. ![]() What my method was, was to place a thumbtack at the initial discovery, then run over it again place a second tack on the different spot (which was only a few mm off.). The Zircon does have a deep scan and center finding option, I found with our walls which are covered in a texture like you put on the celieng, you would pass over the stud once and it would find it but you go over it again and it's a little off. Therefore, if you really want to replace your lath and plaster walls with drywall, then you need to remove the plaster walls completely down to the studs. A finished drywall wall ready for painting. I did have to go over the walls a few times where the stud was just to make sure I had the stud and the center. Your only insulation option is going to be blown-in insulation. I did go get a Zircon i350and that actually seemed to do the job. Thanks for all your suggestions, they offered me several options. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |